Image 3 of 719
September 17, 2007
No more Plastic Blocks!! Here is a view during the drivetrain mockup. That's the real deal - Dynoed at 637hp, over 600 lb ft or torque and a nice burble at a pump gas idle of 850 rpm. And look sharp below the alternator - Yup, that is an A/C compressor - this one is getting one of our "Hidden A/C" installs!
Cross ram 472ci Hemi, Stage V Engineering Aluminum heads built by Todd Marsh of Marsh Performance (Who builds and Dyno's all of our motors). http://www.marshperformance.com/
A full-on pro street manual valve body 727 trans with a billet front drum, hand built by John Cope of Cope Racing Transmissions (Who builds all of our Transmissions).
http://coperacingtransmissions.com/osCommerce/catalog/
A monster Dana 60 with 3:55 gears, Detroit Locker and custom rear dish brakes built by Cass Eslick (known as Dr. Diff) from Pulson Montana - who builds all of our rears.
And an RMS Chasis built "Alterkation" coil over front end with a set of Wildwood 4 piston disk brakes and power rack & pinion. Bill Reily of RMS builds all our coil over front ends!
No more Plastic Blocks!! Here is a view during the drivetrain mockup. That's the real deal - Dynoed at 637hp, over 600 lb ft or torque and a nice burble at a pump gas idle of 850 rpm. And look sharp below the alternator - Yup, that is an A/C compressor - this one is getting one of our "Hidden A/C" installs!
Cross ram 472ci Hemi, Stage V Engineering Aluminum heads built by Todd Marsh of Marsh Performance (Who builds and Dyno's all of our motors). http://www.marshperformance.com/
A full-on pro street manual valve body 727 trans with a billet front drum, hand built by John Cope of Cope Racing Transmissions (Who builds all of our Transmissions).
http://coperacingtransmissions.com/osCommerce/catalog/
A monster Dana 60 with 3:55 gears, Detroit Locker and custom rear dish brakes built by Cass Eslick (known as Dr. Diff) from Pulson Montana - who builds all of our rears.
And an RMS Chasis built "Alterkation" coil over front end with a set of Wildwood 4 piston disk brakes and power rack & pinion. Bill Reily of RMS builds all our coil over front ends!